Skip to Main Content
IEEE membership options for an individual and IEEE Xplore subscriptions for an organization offer the most affordable access to essential journal articles, conference papers, standards,
eBooks, and eLearning courses.
Learn more about:
IEEE Xplore subscriptions
Your organization might have access to this article on the publisher's site. To check,
click on this link:http://dx.doi.org/+10.1063/1.1704862
Laser lift-off technique was employed to carry out transfer of prefabricated InGaN multiple-quantum-well light-emitting diodes (LEDs) from sapphire onto Cu substrate. Silver epoxy was used as the bonding material. Characterization results showed tremendous device improvements in terms of maximum allowable current, light output power, and reliability from the use of conductive Cu substrate. LEDs on Cu could withstand a maximum current of 530 mA before breakdown while those on sapphire could only withstand 350 mA. At 40 mA, light output power of LEDs on sapphire and Cu was 0.74 and 0.95 mW, respectively. In addition, reliability test at constant current of 300 mA showed improvement in light output power for LEDs on Cu whereas LEDs on sapphire suffered deterioration with time. © 2004 American Institute of Physics.
A not-for-profit organization, IEEE is the world's largest professional association for the advancement of technology.
© Copyright 2014 IEEE - All rights reserved. Use of this web site signifies your agreement to the terms and conditions.