The CellChip is a microstructured polymer scaffold, which favours a three-dimensional cultivation of cells within an array of cubic microcontainers. The manufacturing process used so far is microinjection moulding combined with laser-based perforation. In a first attempt to simplify the process, costly perforation was avoided by using commercially available, inexpensive microfiltration membranes for the bottom of the microcavities. Microthermoforming is a promising novel technique which allows the CellChip to be produced from thin film. Working pressures of approximately 4000 kPa were required for the adequate moulding of 50 μm thick films from three different polymers (polystyrene, polycarbonate, cyclo-olefin polymer). Integrating drafts and chamfers in micromoulds is not going to eliminate an uneven thickness profile, but reduces demoulding forces. Microthermoformed CellChips of polycarbonate were perforated by an ion track technique to guarantee a sufficient supply of medium and gases to the cells. The prestructured CellChips were irradiated with 1460 MeV xenon ions at a fluence of a few 106 ions/cm2. The tracks were etched in an aqueous solution of 5N NaOH at 30°C, which resulted in cylindrical pores approximately 2 μm in diameter. Microinjection-moulded, membrane-bonded and thermoformed CellChips were subjected to comparative examination for viability in a cell culture experiment with parenchymal liver cells (HepG2). The cells stayed viable over a period of more than 20 days. No significant differences in viability between injection-moulded, membrane-bonded, and thermoformed CellChips were observed.