Cardiac Strain Imaging With Coherent Compounding of Diverging Waves

Current methods of cardiac strain imaging at high frame rate suffer from motion matching artifacts or poor lateral resolution. Coherent compounding has been shown to improve echocardiographic image quality while maintaining a high frame rate, but has never been used to image cardiac strain. However, myocardial velocity can have an impact on coherent compounding due to displacements between frames. The objective of this paper was to investigate the feasibility and performance of coherent compounding for cardiac strain imaging at a low and a high myocardial velocity. Left-ventricular contraction in short-axis view was modeled as an annulus with radial thickening and circumferential rotation. Simulated radio-frequency channel data with a cardiac phased array were obtained using three different beamforming methods: single diverging wave, coherent compounding of diverging waves, and conventional focusing. Axial and lateral displacements and strains as well as radial strains were estimated and compared to their true value. In vivo feasibility of cardiac strain imaging with coherent compounding was performed and compared to single diverging wave imaging. At low myocardial velocities, the axial, lateral, and radial strain relative error for nine compounded waves (16.3%, 40.4%, and 18.9%) were significantly lower than those obtained with single diverging wave imaging (19.9%, 80.3%, and 30.6%) and closer to that obtained with conventional focusing (16.7%, 43.7%, and 16%). In vivo left-ventricular radial strains exhibited higher quality with nine compounded waves than with single diverging wave imaging. These results indicate that cardiac strain can be imaged using coherent compounding of diverging waves with a better performance than with single diverging wave imaging while maintaining a high frame rate, and therefore, has the potential to improve diagnosis of myocardial strain-based cardiac diseases.