Feasibility Study of the Impregnation of a No-Insulation HTS Coil Using an Electrically Conductive Epoxy

This paper reports the feasibility of the impregnation of no-insulation (NI) high-temperature superconducting (HTS) coils using an electrically conductive epoxy resin. Recently, several studies of HTS coils without turn-to-turn insulation have been reported for field coils used in rotating machines such as motors and generators. The NI winding technique enhances the thermal stability of the HTS coil without requiring complicated protection techniques because the quench current is automatically bypassed through the turn-to-turn contacts within the HTS coil. Nevertheless, there is still a question as to whether the NI technique can be applied to rotating machines. To utilize an HTS coil under high mechanical loads such as field coils for rotating machines, the HTS tapes must be stabilized mechanically. For HTS field coils intended for use in rotating machines, epoxy impregnation is generally necessary to protect the HTS field coil from mechanical disturbances caused by the magnetic field and rotational vibration of the rotor to enhance the mechanical stability [1], [2] . However, the NI HTS coil cannot be fabricated by wet winding using epoxy resin because epoxy resins such as Stycast 2850 FT and CTD 521 are electrically insulating materials. This study examines the electrical stability of an NI HTS coil impregnated with an epoxy resin containing electrically conductive particles. The results are likely to present useful data for the application of electrically conductive epoxy impregnated NI HTS coils to rotating machines.