A miniature digital current sensor with differential Hall probes using enhanced chopping techniques and mechanical stress compensation

A 10kHz bandwidth 50Amax current sensor using a Hall effect gradiometer without magnetic core provides 80kHz update rate with a digital interface. Very low un-calibrated offset of 30mA (1σ) and after calibration typical 10mA over temperature is accomplished by a chopped multi-bit feedback continuous-time 3rd order ΔΣ-ADC. This also realizes low noise of 13mA
_rms
in 1kHz signal bandwidth. The ADC uses enhanced chopping techniques and additional digital feedback loops to avoid chopper ripple. New analog and digital stress-compensation circuits with lateral and vertical n-doped resistors achieve lifetime gain drifts below 1% and temperature compensation. Auto-zeroing ping-pong comparators offer a fast over-current detection of 1...2μs on a dedicated output pin. The monolithic integrated sensor chip and the 4kV galvanic isolated current rail fit into a very small 7×7×1mm
³
package.