Surface roughness prediction based on processing parameters in abrasive jet finishing with grinding wheel as restraint

Based on the modeling and experiments concerning the surface roughness in abrasive jet finishing with grinding wheel as restraint, the effect of abrasive size, abrasive fluid concentration, machining cycles, wheel velocity and carrier fluid on machined surface quality was investigated. Surface grinder KP-36 was employed in a jet machining experiment conducted with W18Cr4V and 40Cr materials, profilometer TALYSURF was used to measure the micro geometrical parameters after machining, and SEM was used to observe surface micro-morphology. Experimental results show that with W7 Al
₂
O
₃
powder at the mass fraction of 10% and antirust lubricating liquid being adopted in jet machining for 20 to 30 cycles, not only high surface shape precision can be kept or obtained, but also defect-free machined surface with the roughness of Ra 0.15~1.6 μm can be obtained with high efficiency. Such a new surface finishing method integrating grinding and polishing can well remove excessive plastic deformation in grinding, reduce surface pollution and grinding burning, and achieve high efficiency, high precision and low roughness values. Experimental observation and experimental results proved that the experimental results agree well with a mechanism-based machining model.