Measurement of MCG in Unshielded Environment Using a Second-Order SQUID Gradiometer

In this paper, we fabricated a low-T
_C
second-order superconducting quantum interference device gradiometer (SQUID) to measure magnetocardiography (MCG) in unshielded environment. The second-order gradiometer consists of the pickup coil and the SQUID. The pickup coil is formed with two single-turn coils and one double-turn coil. The three coils are connected in order of single-, double-, and single-turn coil. The coupling polarity of two single coils is opposite to the double-turn coil. The SQUID is based on double relaxation oscillation SQUID (DROS), which consists of a hysteretic signal SQUID, a reference junction, and shunted a relaxation circuit with a resistor and an inductor. The DROS has ten times larger flux-to-voltage transfer coefficient (~ 1 mV/Phi
₀
) than that of the conventional SQUID. Therefore, DROS could be operated with a simple flux-locked loop circuit. The pickup coil and the SQUID were fabricated on the independent wafers and connected superconductively using an Nb wire. The overall size of the second-order gradiometer is 94 times 12 mm
²
with a baseline of 35 mm. The average field noise was about 8 fT /radicHz at 100 Hz with the second-order gradiometer in shielded or unshielded environment. The noise level is low enough to measure MCG signals in the unshielded environment. Finally, we measure the MCG in shielded and unshielded environments by using the second-order gradiometer and compared the signal characteristics measured in both environments.