Photovoltaic cell electrical heating system for removing snow on panel including verification

Smalt photovoltaic plants in private ownership are typically rated at 5 kW(peak). The panels are mounted on roofs at a decline angle of 20° to 45°. In winter time, a dense layer of snow at a width of e.g. 10 cm keeps off solar radiation from the photovoltaic cells for weeks under continental climate conditions. Practically no energy is produced over the time of snow coverage. Only until outside air temperature has risen high enough for a rather long time interval to allow partial melting of snow the snow layer rushes down in an avalanche. Following this proposal, snow removal can be arranged electrically at an extremely positive energy balance in a fast way. A photovoltaic cell is a large junction area diode inside with a threshold voltage of about 0.6 V to 0.7 V (depending on temperature). This forward voltage drop created by an externally driven current through the modules can be efficiently used to provide well-distributed heat dissipation at the cell and further on at the glass surface of the whole panel. The adhesion of snow on glass is widely reduced through this heating in case a thin water film can be produced by this external short time heating. Laboratory experiments provided a temperature increase through rated panel current of more than 10°C within about 10 minutes. This heating can initiate the avalanche for snow removal on intention as described before provided the clamping effect on snow at the edge of the panel frame is overcome by an additional heating foil. Basics of internal cell heat production, heating thermal effects in time course, thermo-graphic measurements on temperature distribution, power circuit opportunities including battery storage elements and snow-removal under practical conditions are described.