Inhomogeneity of currents in a wire array during its exploding phase

The current in a wire array during its exploding phase has been studied. The wire array consisting of many thin wires is used as a plasma source in a z-pinch X-ray radiation system. The current distribution in the exploding wire array plays an important role in producing an initial symmetrical plasma. In the present experiment, four tungsten wires of 0.1 mm in diameter were exploded in a vacuum. The experiment was carried out with an inductive voltage adder pulsed power generator providing a current of 160 kA at quarter period of 1.8 /spl mu/s The currents through and the voltage across the wires were measured simultaneously. It was found that the currents in the wires were inhomogeneous, especially after the wires became plasma. Once the currents became inhomogeneous, the inhomogeneity remained throughout the discharge. It was also studied how the dimensions of the wires affected the homogeneity of the currents. Wires of different lengths or different cross sectional areas resulted in strong inhomogeneities of the currents. The wires with shorter length or smaller cross-sectional area became plasmas earlier than other wires. Thus, the resistances of the wires were not equal. These differences in the resistance caused the inhomogeneity of the currents.