Detection of fatigue in the isometric electrical activation of paralyzed hand muscles of persons with tetraplegia

Paralyzed muscle fatigue is the eventual depression of force due to either prolonged or repetitive electrical stimulation of motor units. The robustness and safety of future functional electrical stimulation (FES) systems will rely on their ability to detect the onset of muscle fatigue. The relative degree of muscle activation can be estimated by monitoring the M-wave. The aim of this study was to test a proposed method of quantitative fatigue assessment that detects muscle force output and its corresponding M-wave measured concurrently. The detection of force and M-wave concurrently allows any reduction in muscle force output to be attributed to either changes in the fatigue state of the stimulated muscle or changes in the degree of stimulus activation of that muscle. The fatigue assessment scheme can thereby accommodate the corresponding changes in muscle force caused by an alteration in the stimulation intensity during fatigue. The Extensor Digitorum Communis (EDC), Extensor Pollicis Longus (EPL), and Flexor Pollicis Longus (FPL) muscles of two C5/C6 tetraplegic men were studied. Stimulation recruitment tests over the pulsewidth range from 0 to 200 /spl mu/s, were performed at intervals during 20 min of maximal stimulation (200 /spl mu/s). Muscle force correlated to the M-wave parameter, second phase area, with mean correlation coefficients of greater than 0.82, when the muscle was in either a nonfatigued or fatiguing state. After the initial force, likely to be primarily due to the fast glycolytic (FG) motor units, had declined the M-wave demonstrated only minor changes throughout the fatigue of muscle force during 20 min of constant maximal stimulation. The second phase area and root-mean-square (rms) of the M-wave reflected muscle activation during modulated stimulation and also remained relatively constant during the fatigue-related force decline when the muscle was stimulated at a constant intensity. This detection of M-wave parameters satisfies the defined requirement for a myoelectric parameter that indicates electrical activation, but is relatively invariant to muscular fatigue.