Ancillary Services via VSIs in Microgrids With Maximum DC-Bus Voltage Utilization

Grid-interactive inverters allow distributed generation units to provide various ancillary services in microgrids. As the linear modulation region of inverters is restricted by the dc-bus voltage, providing ancillary services may drive the fundamental positive-sequence inverter voltage to the overmodulation region. Therefore, to operate in the linear modulation region the maximum active- and reactive-power of the inverter may have to be reduced unless pulsewidth modulation (PWM) references are adjusted. In this paper, an atypical PWM method is proposed for maximizing dc-bus utilization of grid-interactive two-level voltage source inverters (2L-VSI) providing ancillary services. Two important ancillary services, i.e., negative-sequence compensation and harmonic compensation are considered in this paper. The proposed method increases the maximum active- and reactive-power that a 2L-VSI can deliver when providing ancillary services by injecting a common-mode component in the references computed based on instantaneous reference magnitudes. The validity of the proposed technique is verified through simulation, as well as experimental data obtained using a 208-V three phase grid-connected 2L-VSI.