Shielding requirements of a SPECT insert for installation in a PET/MRI system

The objective of this work is to evaluate the shielding requirements of a SPECT insert for installation in the Siemens Biograph mMR in order to perform simultaneous SPECT/MR imaging of the human brain. We intend to use the radionuclides
^99m
Tc,
¹²³
I and
¹¹¹
In. The main photopeaks of these radionuclides have the following energies: 140.5, 159.0, 171.3 and 245.4 keV. There is also about ~3% of emission probability of high energy gamma photons for
¹²³
I in the range of 248-784 keV. The main constraints to the design of the gamma shielding are the presence of high energy photons, the weight, the MR compatibility and the PET LSO crystals intrinsic activity. We used GATE to simulate a SPECT acquisition, defining an MRI system with LSO crystals, a partial SPECT ring and a NEMA phantom. We also defined a lead (Pb) base plate (BP) to simulate the support system and three Pb shielding volumes with variable thickness: front and end (FE), back (B), and lateral (L) shield. These volumes reduce interference from out-of-field activity, LSO intrinsic activity and edge effects, respectively. We performed 4 sets of simulations, with variable FE, variable B, variable L and variable BP thickness, respectively, with a NEMA phantom filled with 185 MBq of
¹²³
I or
¹¹¹
In. For all simulations, we compared the different energy spectra and count-distribution plots. Results show that a Pb shielding configuration with a thickness of 6 mm-F, 2 mm-E, 3 mm-B, and 5 mm-L is appropriate for the insert. For
¹²³
I there is still a high contribution from high energy photons, as the amount of shielding is limited by weight, however this contribution is likely to be overestimated in the simulations as compared to practice. The effect of the LSO intrinsic activity is negligible at the energies of interest.