Contamination control for gas delivery from a liquid source in semiconductor manufacturing

Gas delivery from a liquid source, common in semiconductor manufacturing, raises contamination control concerns not only due to impurity levels in the source. In addition, the lower vapor pressure of impurity species compared to that of the host (source) species causes impurity concentrations in delivered gas to increase as the source is used up. A physics-based dynamic simulator to describe the time-dependent variation of impurity level in such a gas delivery system has been developed and applied to the important case of CHClF/sub 2/ impurities in host CHF/sub 3/ liquid, as routinely used for dry etching processes. The time-dependence of CHClF/sub 2/ impurity concentration is also dependent on the operating temperature of the liquid source: for higher temperatures, the fast rise in impurity concentration and the liquid-dry point occur earlier, while the final impurity level after this point is lower. The dynamic simulator represents a useful tool for avoiding contamination problems with liquid delivery systems and for optimizing materials usage (for cost and environmental benefits) by structuring source usage procedures consistent with contamination-sensitivity of the process. The results also suggest benefits in materials usage if specific source temperatures (different from room temperature) were imposed. The physical basis of the dynamic simulator allows more general application to other systems.