The Influence of Pixel Pitch and Electrode Pad Size on the Spectroscopic Performance of a Photon Counting Pixel Detector With CdTe Sensor

The quality and availability of room temperature CdTe sensor material for X-ray detection has improved significantly in the last years. A CdTe sensor with different pixel pitches and electrode pad sizes was bump-bonded to a Medipix2-MXR ASIC. With this photon counting detector we were able to investigate the influence of pixel pitch and electrode pad size on the energy response functions. The accurate knowledge of the energy response is crucial for energy resolving X-ray imaging. Therefore we exposed the detector to gamma rays of
²⁴¹
Am and
⁵⁷
Co. In the following analysis of the energy response spectra we determined the number of events in the photo peak, the energy resolution and the threshold energy where the photo peak is found (photo peak position) caused by the absorption of the 59.5 keV photons of
²⁴¹
Am. For the energy calibration we used the 59.5 keV photons of
²⁴¹
Am and the 122 keV photons of
⁵⁷
Co. Concerning energy resolution, energy threshold calibration and photo peak position our measurements show good agreement with the expected behaviour. The number of events in the photo peak strongly depends on the pixel pitch and the electrode pad configuration.