A Synchronous Chopping Demodulator and Implementation for High-Frequency Inductive Position Sensors

We describe a new method for high-frequency precision sensing. The method combines synchronous detection with chopping in a fully differential architecture that includes an instrumentation amplifier. An integrated circuit implementation of the proposed synchronous chopping demodulator front end was designed and fabricated in a 0.35-mum CMOS process technology and tested with high-frequency inductive position sensors. The measured results show that the new technique offers considerable advantages in terms of offset reduction compared to traditional techniques for these sensors, which rely on a microcontroller to measure the offset before each position measurement is taken. The measured average input-referred offset for the 20 fabricated chip samples is 87 muV at a chopping frequency of 500 kHz when the resonant target is off and synchronous demodulation and transmitter excitation are both applied at 1 MHz. The technique, in addition to improving system resolution and immunity to common-mode interference, allows these high-frequency position sensors to work with multiple targets, thus increasing speed and functionality.