Final Assembly and Installation of the ITER TF Coils

The toroidal magnetic field of ITER is provided by 18 Nb
₃
Sn superconducting coils that provide 5.3 T in the Tokamak magnetic centre thanks to a nominal current of 68 kA. Two major procurement packages will be integrated to accomplish the final assembly of the coils: 1) the winding pack which houses the double pancakes in 7 stacked radial plates (RP) and 2) the TF coil case which houses the winding pack (WP) and is the main structural component of the ITER machine. 19 TF coil cases (18+1 spare) will be entirely procured by Japan, whereas the WP and the TF coil assembly will be shared between Japan (9) and Europe (10). The insertion process of the WP inside the coil case, VPI and final closure welding is presented with an emphasis on the R&D still remaining. An appropriate metrology strategy and correct benchmarking of the WP current center line (CCL) in the coil case external walls is essential to allow the correction of the error fields during operation. The TF coils will be assembled and pre-aligned in pairs together with their corresponding VV sector and craned to the Tokamak hall hanging from 2 independent hooks. The integration of the TF coils in the Tokamak primary datum system will have to be accomplished within the maximum tolerances defined by the error field analysis. As-built 3D data collected during manufacture will be used to ensure the correct positioning of the CCL against the Tokamak datum system and ease the alignment process. Shimming will be used in the gravity support for vertical alignment and in the upper and lower OIS for toroidal alignment. A subsequent survey of the 'as-installed' TF coils will determine the final Tokamak Datum System.