2.4 GHz ISM-Band Receiver Design in a 0.18 $\mu{\hbox{m}}$ Mixed Signal CMOS Process

This letter presents the design and measurement results of a fully integrated CMOS receiver front-end and voltage controlled oscillator (VCO) for 2.4 GHz industrial, scientific and medical (ISM)-band application. For low cost design, this receiver has been fabricated with a 0.18 mum thin metal CMOS process with a top metal thickness of only 0.84 mum. The receiver integrates radio frequency (RF) front-end (a single-ended low-noise amplifier (LNA) with on-chip spiral inductors and a double balanced down conversion mixer), VCO and local oscillation buffers on a single chip together with an internal output buffer. To obtain the high-quality factor inductor in LNA, VCO and down conversion mixer design, patterned-ground shields (PGS) are placed under the inductor to reduce the effect from image current of resistive Si substrate. Moreover, in VCO and mixer design, due to the incapability of using thick top metal layer of which the thickness is over 2 mum, as used in many RF CMOS process, the structure of dual-metal layer in which we make electrically short circuit between the top metal and the next metal below it by a great number of via arrays along the metal traces is adopted to compensate the Q -factor degradation. In this letter, the receiver achieves a conversion gain of 23 dB, noise figure of 8.1 dB and P1 dB of -20 dBm at 39 MHz with 21 mW power dissipation from a 1.8 V power supply. It occupies a whole circuit area of 2 mm
²
.