Conventional contact interconnect technology as an alternative to contact plug (W) technology for 0.85 /spl mu/m CMOS EPROM IC devices

The conventional (plug-less) and tungsten (W) plug contact interconnect technologies were studied for the fabrication of 0.85 /spl mu/m CMOS EPROM integrated circuit devices. 4 Mbit EPROM devices and appropriate test structures were fabricated using these two interconnect architectures and were evaluated for process simplicity, associated problems/solutions, contact electrical characteristics, and circuit yield and speed. The most important process issue for the conventional contact technology was the overlay accuracy of the stepper used for printing the contacts. It was found that a misalignment of <0.3 /spl mu/m was essential if contacts were to be reflowed after the contact etch process in a way that: a) did not violate the geometrical design rules, and b) did not result in bulging of the contacts, or an increase in the contact profile angle which would degrade metal step coverage. Electrical characteristics of the contacts were studied through contact resistance, specific contact resistivity, contact failure rate, and junction leakage measurements for both contact interconnect architectures. The data presented indicated that both processes produced contacts with similar characteristics. Finally, the results of this work indicated that the conventional contact interconnect technology could be reliably used for fabrication of 0.85 /spl mu/m CMOS EPROM devices. This process was simpler, less expensive, and as structurally reliable as the W contact plug technology.<
>