Secondary LC filter analysis and design techniques for current-mode-controlled converters

Small-signal characteristics of current-mode-controlled PWM converters with a second-stage LC filter are analyzed. It is shown that a secondary filter can be designed to provide good attenuation of the switching ripple while maintaining adequate stability margins with capacitive loading. The resonant frequencies and damping coefficients of the second filter are derived, and design guidelines are given. It is shown that the current-loop gain of the buck converter is not affected by the addition of the second-stage filters when a small filter inductance is used. Three design examples are presented to demonstrate the use of analysis results. Two filter examples are designed for a buck converter. One of the second filters shows the problems that arise with a poor design. A third example is the design of a second-stage filter for a buck-boost converter. In each of the design examples, the small-signal analysis was performed using EASY5 software and the circuits were simulated using the state-space simulation program COSMIR.<
>