Flyback-Type Single-Phase Utility Interactive Inverter With Power Pulsation Decoupling on the DC Input for an AC Photovoltaic Module System

In recent years, interest in natural energy has grown in response to increased concern for the environment. Many kinds of inverter circuits and their control schemes for photovoltaic (PV) power generation systems have been studied. A conventional system employs a PV array in which many PV modules are connected in series to obtain sufficient dc input voltage for generating ac utility line voltage from an inverter circuit. However, the total power generated from the PV array is sometimes decreased remarkably when only a few modules are partially covered by shadows, thereby decreasing inherent current generation, and preventing the generation current from attaining its maximum value on the array. To overcome this drawback, an ac module strategy has been proposed. In this system, a low-power dc-ac utility interactive inverter is individually mounted on each PV module and operates so as to generate the maximum power from its corresponding PV module. Especially in the case of a single-phase utility interactive inverter, an electrolytic capacitor of large capacitance has been connected on the dc input bus in order to decouple the power pulsation caused by single-phase power generation to the utility line. However, especially during the summer season, the ac module inverters have to operate under a very high atmospheric temperature, and hence the lifetime of the inverter is shortened, because the electrolytic capacitor has a drastically shortened life when used in a high-temperature environment. Of course, we may be able to use film capacitors instead of the electrolytic capacitors if we can pay for the extreme large volume of the inverter. However, this is not a realistic solution for ac module systems. This paper proposes a novel flyback-type utility interactive inverter circuit topology suitable for ac module systems when its lifetime under high atmospheric temperature is taken into account. A most distinctive feature of the proposed system is that the decoupling of power pulsation is executed by an additional circuit that enables employment of film capacitors with small capacitance not only for the dc input line but also for the decoupling circuit, and hence the additional circuit is expected to extend the lifetime of the inverter. The proposed inverter circuit also enables realization of small volume, lightweight, and stable ac current injection into the utility line. A control method suitable for the proposed inverter is also proposed. The effectiveness of the proposed inverter is verified thorough P-SIM simulation and experiments on a 100-W prototype