Thin-film persistent current switch

We have developed a fast, low power heat switch for switching a niobium thin film between the normal and superconducting state. The sputtered niobium film (400 nm thick, 100 /spl mu/m wide) has a critical current density of 5/spl times/10/sup 10/ Am/sup -2/. Switching is produced by joule heating a small section of the niobium film with a titanium thin-film resistor. With the heat switch in vacuum, the minimum heater power needed to switch to the normal state was 4.5/spl times/10/sup -5/ W. A simple three-dimensional thermal model shows that the minimum power is primarily determined by the thermal conductivity of the substrate. We have achieved response times less than 10/sup -6/ s.