A cyclotron-wave rectifier for S-band and X-band

A device for converting microwave power into either dc power or low-frequency ac power has been investigated both theoretically and experimentally. Rotational energy is stored in an electron beam by a Cuccia coupler, then converted to longitudinal energy by interaction with a space-dependent dc magnetic field, and finally recovered as electric energy by a depressed collector. A simple kinematic analysis demonstrates that the Cuccia coupler can convert large amounts of microwave power into electron beam rotation. Limits on the electric field strength and asynchronism between signal frequency and cyclotron frequency are established for both classical and relativistic coupler operation. Efficiency analyses of the process of conversion from orbital energy to dc electric energy, both classical and relativistic, indicate that the efficiency exceeds 95 percent for a particular range of operating conditions. As an ac power supply, the device responds to the modulating frequency of the signal. Theory predicts near-negligible harmonic distortion as well as flatness of frequency response from dc to about 1.0 MHz modulating frequency. Four tubes and a prototype (with "artificial" coupler) were tested experimentally. The first three tubes exhibited efficiencies up to 22 percent, being hindered by reflection of electrons into the coupler. Certain design changes were tested on the prototype, where efficiencies from 36 percent to 75 percent were obtained. Incorporating these design changes into the fourth tube yielded measured efficiencies up to 34 percent, or when corrected to disregard unusually large cavity losses, up to 59 percent. Experimental tests of the tube as an ac converter yielded excellent frequency response and about 20 percent second-harmonic distortion. It is concluded that the theoretical foundation of efficiency predictions has thus far been based on too optimistic assumptions.