Single-conductor strip leaky-wave antenna

This paper presents a leaky-wave antenna with only a single-conductor strip on a substrate without a practical ground plane. The full-wave integral equation method is used to investigate the EH/sub 01/ leaky mode of this single-conductor strip structure. When this single-conductor strip is on a thin substrate with a low dielectric constant, a broad-band radiation regime can exist for the EH/sub 01/ leaky mode. The balanced microstrip lines and the inverted balanced microstrip lines are used to excite this EH/sub 01/ leaky mode. This work presents both the numerically simulated and measured data. The measured bandwidth of a voltage standing-wave ratio /spl les/2 is from 6.55- 13.75 GHz (2.34:1). In this case, the normalized phase constant is very close to 1 and this results in a fixed main-beam radiation pattern in the end-fire direction. This leaky-wave antenna with only a single rectangle stripline of length 110 mm can achieve the same broad-band performance as a tapered microstrip leaky wave antenna with a length 310 mm, as previously reported by the authors.